Product name: 130NC hydraulic semi-automatic pipe bending machine

Attention should be paid to the operation of the machine:

1. When the machine tool starts, the operator must not leave the machine tool.

2. Put the workpiece into the bending mold for normal operation, and the front end is in contact and positioned, and you can complete it by stepping on the foot switch.

3. Adjust the required position and required angle of the parts, adjust the vertical lifting guide rails, so that the guide mold compression cylinder can clamp the iron pipe tightly.

4. During the trial operation of the empty car, check whether the mechanical operation is normal and whether the electrical switch is sensitive and easy to use. After everything is normal, start the work.

5. Start the oil pump, whether the system pressure remains within the specified range, if it is high, it will damage the hydraulic components, waste power, if it is too low, it will affect the work.

6. When two people work at the same time, they should cooperate closely and coordinate with each other. A designated person should be designated to operate the switch. During operation, it is forbidden to chat with others to prevent misoperation.

7. Before operation, first check whether each lubrication point is short of oil, whether the movement mechanism is loose, and whether the safety protection device is reliable. It can be operated only after confirmation.

8. Check whether the protective device on the machine is intact. If it is not installed, it is not allowed to drive. The intermediate frequency pipe bender should have good grounding and electrical insulation, and the voltage should be stable.