There are certain methods when using the pipe bender mold. Only by grasping its operation method can we fully utilize the various convenient and quick benefits brought by the pipe bender mold. The following editor will tell you how to use the mold and safe operation, let's understand it together.

First, the use of electric oil pump should refer to the use of imitation single when using the pipe bender mold.

2. When using the mold, first screw the working oil cylinder into the internal thread of the square stop, so that the wheel mounted on the bracket at the rear end of the oil cylinder is downward.

3. Select the die head according to the outer diameter of the bent tube, put it on the plunger, place the corresponding grooves of the two rollers toward the die head, and then put it into the corresponding size of the flower plate hole, and then cover the upper flower plate , Insert the bent pipe into the groove, and then pull the flow part of the quick connector at the end of the high-pressure fuel pipe back and sleeve it on the joint of the working oil cylinder. Tighten the oil drain screw on the electric oil pump to bend the pipe. After the elbow is finished, loosen the oil drain screw and the plunger will automatically reset.

There are certain risk factors for the use of the pipe bending machine mold: the flow range of the bending arm is more dangerous between the fixed arm and the bending arm, the area of ​​the bending angle selector is more dangerous, the pipe loading and unloading in front of the machine head and the movement of the pipe rotation Space is more dangerous. From this we have come up with a certain study to find the safe way to use: setting an emergency stop button, when pressing this button, it will stop all motor and servo power supply. Avoid overload and abuse of pipe bender molds, confirm the load of the machine during operation, to avoid overloading of machine components, otherwise it will affect the service life of the mold and the safety of the operating staff. The bending ability is the tensile coefficient of a bendable general iron pipe, 40Kg/cm2.

Professional pre-job training and assessment can avoid accidental injuries that may arise during the production process or reduce them to a low degree. Normally, employees should pay attention to the employees' safety concepts about the working environment and machine operation, and put in place important rules such as mold installation instructions, safety devices and operating methods, and personal safety. Insulator circuits always exist at the joints of connectors and do not allow touching. Only allow professional staff to turn on the power accessories. Before using the machine, the voltage of all transformers is changed to the voltage supplied locally for the operation of the machine. The power supply of the mold must be a three-phase power supply and be grounded in accordance with local power regulations. The power supply must be clearly marked.