The operator of the pipe bending machine needs to pass the training of safety operation rules, be familiar with the structure, performance, principle, daily maintenance and programming of the machine, and operate it after passing the assessment. What are the safety operation rules of the pipe bending machine? Xiaobian explain to you, I hope to help you.

1. When the machine tool starts, the operator must not leave the machine tool.

2. Put the workpiece into the bending mold for normal operation, and the front end is in contact and positioned, and you can complete it by stepping on the foot switch.

3. Adjust the required position and required angle of the parts, adjust the vertical lifting guide rails, so that the guide mold compression cylinder can clamp the iron pipe tightly.

4. During the trial operation of the empty car, check whether the mechanical operation is normal and whether the electrical switch is sensitive and easy to use. After everything is normal, start the work.

5. Start the oil pump, whether the system pressure remains within the specified range, if it is high, it will damage the hydraulic components, waste power, if it is too low, it will affect the work.

6. When two people work at the same time, they should cooperate closely and coordinate with each other. A designated person should be designated to operate the switch. During operation, it is forbidden to chat with others to prevent misoperation.

7. Before operation, first check whether each lubrication point is short of oil, whether the movement mechanism is loose, and whether the safety protection device is reliable. It can be operated only after confirmation.

8. Check whether the protective device on the machine is intact. If it is not installed, it is not allowed to drive. The intermediate frequency pipe bender should have good grounding and electrical insulation, and the voltage should be stable.

9. Check the surroundings of the work site to remove any debris that hinders work and traffic. There must be no oil on the ground to prevent slipping, and the work pieces should be stacked neatly and firmly to prevent them from collapsing and hurting people.

10. During work, no one is allowed near the bend range of the pipe, and a protective warning sign is set up. When prying the pipe, stand firmly to prevent it from being injured by the crowbar. The operator can only stand outside.

11. When bending, keep your thoughts focused. It is forbidden to put your hands or other objects into the work area. In case of emergency, press the emergency stop button, and then turn the rotary switch to the manual position. Use manual reset. .

The above is all about the safe operation rules of the pipe bending machine. If there is anything you don’t know, you can communicate with our customer service, we will serve you wholeheartedly.