The installation of pipelines and repairs in factories, warehouses, docks, buildings, railways, automobiles, etc., the fully automatic hydraulic pipe bender can be said to have done a lot. In addition to its pipe bending function, it can also remove the pipe bending parts (cylinder) as a separate hydraulic jacking machine. There are a few things that must be done before the use of fully automatic hydraulic pipe bending machine, do you know?

Here are some points to be done before using the hydraulic pipe bender:

1. Look around the work site and remove all debris that obstructs the operation and traffic. There must be no oil on the ground to avoid slipping. Workpieces should be stacked neatly and firmly to prevent them from collapsing and hurting people.

2. Check whether the protective equipment on the automatic hydraulic pipe bending machine is intact. If it is not installed, it is forbidden to drive. The pipe bender should have good grounding and electrical insulation, and the voltage should be stable.

3. Check the pipe bender. If there is no oil or no oil, add enough oil.

4. During the trial operation of the empty vehicle, check whether the mechanical operation is normal and the electrical switch is sensitive and easy to use. After everything is normal, proceed with the operation.

5. When two people work together, they should cooperate closely and coordinate. A special person should be designated to operate the switch. It is forbidden to talk and laugh with others during operation to prevent misoperation.

6. When the machine tool starts, the operator must not leave the machine tool.

7. When the pipe bending machine is in operation, no one is forbidden in the vicinity of the pipe bending stroke scale, and a protective warning sign is set up. Stand firmly when prying the tube to prevent it from being injured or slipped by the pry bar. The operator can only stand outside.

8. The calibration tube should pay attention to the surrounding safety. The hammer must be immersed in water for a few minutes to prevent the handle from hurting people. Do not wear gloves when knocking on the tube.

The above is the relevant content of the editors about the points that need to be done before using the hydraulic pipe bending machine, and I hope to help you.