欢迎访问Zhangjiagang Junhang Machinery Equipment Co., Ltd.
联系热线:

13913602862

13913602862

How can the pipe cutting machine cut out better?

2020-06-07

How to make a laserPipe cutting machineCut out a good effect? ​​The following is for you, let's understand it together.

1. The cooling system should be grounded, and the water tank and water circuit are often cleaned. The temperature control point of the cooling temperature control water tank should be fair, otherwise it will cause the laser tube to be easily damaged and the dew condensation power will drop, the cold head of the tube will fall off, the life will be greatly shortened, and sometimes it will not work. Keep changing tubes.

2. The laser tube installation fulcrum of the laser tube cutting machine should be reasonable, the fulcrum should be at 1/4 of the total length of the laser tube, otherwise the laser tube spot form will be deteriorated, and the spot will become several points for some operations for a period of time, resulting in laser power The drop could not reach the requirements, resulting in constant tube changes.

3. The water protection should always be checked and cleaned. The cooling water cannot often be flushed with the water protection float switch or the water protection float switch is not reset, and the short-circuit method cannot be used to deal with the urgent needs.

4. The suction equipment should be checked and scheduled on a regular basis, and the fan duct should be cleaned. Otherwise, a lot of smoke and dust will not be discharged, and the lens and laser tube will be severely and quickly polluted, which makes the mechanical and electronic components easy to oxidize and cause poor touch.

5. Viewing the collection mirror and reflector, the frame of the laser cutting machine will become feverish after a while, and the surface of the lens will become discolored and rusty; the film cracking is attributed to the object to be replaced, especially many customers use air pumps and air compressors. In this way, water will quickly accumulate on the collecting lens, so it is necessary to check the cleanliness and quality of the lens optical path system on time.

6. The operating environment of the laser cutting machine should not be too harsh. If the ambient temperature is higher than 30 degrees and lower than 18 degrees, there will be too much dust and severe air pollution. In this way, the machine is severely damaged and the failure rate continues to rise; all electrical accessories in a humid environment It's easy to go wrong.

7. The power of the power grid should be matched.

8. The working current of the laser tube should be fair, and it can not be operated at a light intensity of 90-100 for a long time; the laser should be used reasonably and the laser energy should be saved; the optical path system should be clean and accurate, otherwise the laser tube of the laser cutting machine will be prematurely aged and broken Therefore, the light intensity of the laser machine should be adjusted to 50-60%, and then adjust the operation speed according to the data, so that it is the operation state of the laser tube.

After the above understanding of the pipe cutter, I hope it can help you.

Related News

Product Recommended

  • Oil moving pipe cutti...
  • Fully automatic pipe ...
  • CNC automatic pipe be...
  • 75CNC CNC automatic p...
  • Double-head automatic...
  • TH80DT single head ch...